We utilize this package so that we can assign IP addresses and process DNS requests through the Raspberry Pi itself and act like a router. To setup the Raspberry Pi Wifi bridge we will be utilizing the dnsmasq package, this package handles most of the grunt work for this tutorial.ĭnsmasq is a package that acts as both a local DHCP server and a local DNS server. Equipment Listīelow are all the bits and pieces that I used for this Raspberry Pi Wi-Fi bridge tutorial, you will need A Wireless internet connection to be able to complete this tutorial. Please note: This tutorial will require some slight changes if you decide to go down the VPN route, we will explain the necessary changes needed at the end of this tutorial. Basically, it will show how to setup a OpenVPN client and redirect all traffic through that client. This tutorial can be combined with our basic VPN access point, you can find the tutorial on how to set that up directly after this tutorial. Remember to do this tutorial you will need either a WiFi dongle or a Raspberry Pi 3 with the inbuilt WiFi module. As there is some overhead with the connection having to run through the Raspberry Pi. ![]() ![]() You will need to keep in mind that you will not see speeds as good as what you would with a direct connection to your router. ![]() In this tutorial, we will show you how to setup a WiFi bridge, and how to setup dnsmasq correctly to allow any device to connect through your Pi without issues.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |